MOULD (名詞・動詞) 型・成形（成型）する
2013年10月05日
目次はこちら
MOULD (n, v) 型・成形（成型）する
$$ After 30 minutes a two stage rotary vacuum pump was attached to the mould and maximum vacuum applied. / ３０分後、２段階ロータリー真空ポンプを型に接続して、最大限に真空にした。(USP6689832)
$$ In a preferred manufacturing process the support sheet 1050 is prepared by a moulding process. (USP6585162)
$$ This is made from upper and lower moulded plastic shells 101, 102. / 上記構造は､上方及び下方鋳型プラスチックシェル１０１､１０２から構成される｡(USP6422434)
$$ The set specimens were removed from the mould. / 凝結した試験片を型から外した｡(USP6313192)
$$ As is conventional the seat backs (203) are shells moulded from a suitable plastics material. (USP6332029)
$$ The uppermost layer is a silicone rubber moulded layer 2801, identical to layer 704 previously described in reference to FIG. 7. (USP6585162)
$$ The nozzle tip has a separate moulded module 32 fitted onto the end of the main inclined run 31 of the nozzle. / ノズルチップは、該ノズルの主傾斜操作部３１の端部に嵌合された別個の鋳型モジュール３２を備える。(USP6422434)
$$ Each part 1 and 2 is moulded from a plastics material and is divided diametrically but hingedly joined at an edge 12 and 13. (USP4160610)
目次はこちら
MOULD (n, v) 型・成形（成型）する
$$ After 30 minutes a two stage rotary vacuum pump was attached to the mould and maximum vacuum applied. / ３０分後、２段階ロータリー真空ポンプを型に接続して、最大限に真空にした。(USP6689832)
$$ In a preferred manufacturing process the support sheet 1050 is prepared by a moulding process. (USP6585162)
$$ This is made from upper and lower moulded plastic shells 101, 102. / 上記構造は､上方及び下方鋳型プラスチックシェル１０１､１０２から構成される｡(USP6422434)
$$ The set specimens were removed from the mould. / 凝結した試験片を型から外した｡(USP6313192)
$$ As is conventional the seat backs (203) are shells moulded from a suitable plastics material. (USP6332029)
$$ The uppermost layer is a silicone rubber moulded layer 2801, identical to layer 704 previously described in reference to FIG. 7. (USP6585162)
$$ The nozzle tip has a separate moulded module 32 fitted onto the end of the main inclined run 31 of the nozzle. / ノズルチップは、該ノズルの主傾斜操作部３１の端部に嵌合された別個の鋳型モジュール３２を備える。(USP6422434)
$$ Each part 1 and 2 is moulded from a plastics material and is divided diametrically but hingedly joined at an edge 12 and 13. (USP4160610)
目次はこちら
※このブログではブログの持ち主が承認した後、コメントが反映される設定です。