TAKE VALUE 値をとる
2016年01月04日
車馬駄馬田 at 08:00 | Comments(0) | take
目次はこちら
TAKE VALUE 値をとる
$$ In the case where uniform demand takes the value of 4 the process rapidly finds a zero interference solution. / 均一の需要が4の値をとる場合に、このプロセスではゼロ干渉の解を迅速に見付ける。(USP6539228)
$$ ...where the subscript i takes values from 1 to the number of nodes sharing the downstream interface.... / なお、下付き文字iは1ないし下流インターフェイスを共有するノード数の値をとる (USP6163807)
$$ For low values of Ijk, (implying low interference) it is possible for Ujkt to take a value greater than 1 if N is large. / Ijkの低い値において、Ujktは(低い干渉を意味する)、Nが大きいときに、1よりも大きい値をとることができる。(USP6539228)
$$ A unary digit can take on any of the two values 0, 1 or alternatively can be defined to take on only the single value 1, and its absence is then used to represent 0 somewhat as in Roman Numeral notation. (USP6373955)
$$ The unwrapping can be carried out with fewer phase maps, and under most conditions more reliably, by taking only the phase values in the sequence t=1,2,4 ... s, corresponding to the case K=2. / アンラッピングは、少数の位相マップを用いて、および信頼できる殆どの条件下で、場合K=2に相当するシーケンスt=1、2、4・・・sでの位相値のみを求めて行なうことができる。(USP6208416)
$$ It may typically be 80% of the original value of the portfolio, but could take any value chosen by the operator, e.g. from 60% to 90%. (USP01027430)
目次はこちら
TAKE VALUE 値をとる
$$ In the case where uniform demand takes the value of 4 the process rapidly finds a zero interference solution. / 均一の需要が4の値をとる場合に、このプロセスではゼロ干渉の解を迅速に見付ける。(USP6539228)
$$ ...where the subscript i takes values from 1 to the number of nodes sharing the downstream interface.... / なお、下付き文字iは1ないし下流インターフェイスを共有するノード数の値をとる (USP6163807)
$$ For low values of Ijk, (implying low interference) it is possible for Ujkt to take a value greater than 1 if N is large. / Ijkの低い値において、Ujktは(低い干渉を意味する)、Nが大きいときに、1よりも大きい値をとることができる。(USP6539228)
$$ A unary digit can take on any of the two values 0, 1 or alternatively can be defined to take on only the single value 1, and its absence is then used to represent 0 somewhat as in Roman Numeral notation. (USP6373955)
$$ The unwrapping can be carried out with fewer phase maps, and under most conditions more reliably, by taking only the phase values in the sequence t=1,2,4 ... s, corresponding to the case K=2. / アンラッピングは、少数の位相マップを用いて、および信頼できる殆どの条件下で、場合K=2に相当するシーケンスt=1、2、4・・・sでの位相値のみを求めて行なうことができる。(USP6208416)
$$ It may typically be 80% of the original value of the portfolio, but could take any value chosen by the operator, e.g. from 60% to 90%. (USP01027430)
目次はこちら
※このブログではブログの持ち主が承認した後、コメントが反映される設定です。