POWER-UP 電源投入・電力上昇
2014年06月20日
車馬駄馬田 at 08:00 | Comments(0) | po...
目次はこちら
POWER-UP 電源投入・電力上昇
$$ On power-up of the monitoring apparatus, there is a need to check between the two-wheel and four-wheel mode and use a flight or ground indicator to initialise the monitoring apparatus in gear-up (state 61) and monitoring states. / モニターの電源投入時には、二輪モードと四輪モードとを検査し、又、飛行/地上インジケーターを使用して、モニターを着陸装置引込(ギア・アップ)状態(状態61)及び監視状態に初期化する必要がある。(USP8055396)
$$ The circuit IC4 operates only on power-up of the apparatus and is then dormant afterwards, demanding less than a milliamp of current. (USP6752951)
$$ An R C voltage divider formed by resistor 246 and the capacitor 245 sends a pulse to the reset pin of the counter 241 to reset the counter on power-up. (USP6404608)
$$ Since all switches 130, at least after a full power-up, will be initially in topology determination mode, SwitchBeacon command cells will be ignored by other switches 130 as up channel control cells. (USP6396815)
$$ This is because the switch 24 also serves as a "power-up" key for turning the pen on or powering it up after it has been powered down. / この理由は、スイッチ24が、ペンをターンオンする、またはその電力が低下せしめられた後に、その電力を上昇させるための、「電力上昇」キーとしても働くからである。(USP6058304)
$$ Referring now to FIG. 2, on power-up the EPROM 6 sets the logic within the field programmable gate array 5. (USP5610507)
目次はこちら
POWER-UP 電源投入・電力上昇
$$ On power-up of the monitoring apparatus, there is a need to check between the two-wheel and four-wheel mode and use a flight or ground indicator to initialise the monitoring apparatus in gear-up (state 61) and monitoring states. / モニターの電源投入時には、二輪モードと四輪モードとを検査し、又、飛行/地上インジケーターを使用して、モニターを着陸装置引込(ギア・アップ)状態(状態61)及び監視状態に初期化する必要がある。(USP8055396)
$$ The circuit IC4 operates only on power-up of the apparatus and is then dormant afterwards, demanding less than a milliamp of current. (USP6752951)
$$ An R C voltage divider formed by resistor 246 and the capacitor 245 sends a pulse to the reset pin of the counter 241 to reset the counter on power-up. (USP6404608)
$$ Since all switches 130, at least after a full power-up, will be initially in topology determination mode, SwitchBeacon command cells will be ignored by other switches 130 as up channel control cells. (USP6396815)
$$ This is because the switch 24 also serves as a "power-up" key for turning the pen on or powering it up after it has been powered down. / この理由は、スイッチ24が、ペンをターンオンする、またはその電力が低下せしめられた後に、その電力を上昇させるための、「電力上昇」キーとしても働くからである。(USP6058304)
$$ Referring now to FIG. 2, on power-up the EPROM 6 sets the logic within the field programmable gate array 5. (USP5610507)
目次はこちら
※このブログではブログの持ち主が承認した後、コメントが反映される設定です。