THAN EITHER どちらよりも、いずれよりも
2016年01月22日
車馬駄馬田 at 08:00 | Comments(0) | than
目次はこちら
THAN EITHER どちらよりも、いずれよりも
$$ If the barrier electrodes are more positive than this, there may be a point in time as one clock electrode becomes low, and the next becomes high, when the barrier electrode is more positive than either of the clock electrodes. / 障壁電極がこれよりも高い正電位である場合には、障壁電極がクロック電極のいずれかよりも高い正電位になると、１つのクロック電極がｌｏｗになり、次がｈｉｇｈになる時点が存在することができる。(USP7619201)
$$ The major disadvantage with the mark/sweep (tracing) technique is the lost down time while work stops, and its greater complexity than either of the two previous techniques. (USP02029357)
$$ It has the disadvantage of requiring more processing than either of the other two methods described here. (USP6128086)
$$ Scaling can be used but is of less importance within the context of sonar scene matching than either translation or rotation. / 大きさの変化は使用できるが、ソナー光景の一致の文脈では、平行移動又は回転移動よりも重要性は低い。 (USP7124022)
$$ The cross member 126 is thinner than either of the lower and upper portions 122 and 128 and is designed to fail when a pre-determined shear load is applied, the presence of the groove 124 ensures a more uniform failure mode by acting as a failure initiator. (USP6145870)
目次はこちら
THAN EITHER どちらよりも、いずれよりも
$$ If the barrier electrodes are more positive than this, there may be a point in time as one clock electrode becomes low, and the next becomes high, when the barrier electrode is more positive than either of the clock electrodes. / 障壁電極がこれよりも高い正電位である場合には、障壁電極がクロック電極のいずれかよりも高い正電位になると、１つのクロック電極がｌｏｗになり、次がｈｉｇｈになる時点が存在することができる。(USP7619201)
$$ The major disadvantage with the mark/sweep (tracing) technique is the lost down time while work stops, and its greater complexity than either of the two previous techniques. (USP02029357)
$$ It has the disadvantage of requiring more processing than either of the other two methods described here. (USP6128086)
$$ Scaling can be used but is of less importance within the context of sonar scene matching than either translation or rotation. / 大きさの変化は使用できるが、ソナー光景の一致の文脈では、平行移動又は回転移動よりも重要性は低い。 (USP7124022)
$$ The cross member 126 is thinner than either of the lower and upper portions 122 and 128 and is designed to fail when a pre-determined shear load is applied, the presence of the groove 124 ensures a more uniform failure mode by acting as a failure initiator. (USP6145870)
目次はこちら
※このブログではブログの持ち主が承認した後、コメントが反映される設定です。