IF...WHEN / WHEN...IF
2012年11月15日
車馬駄馬田 at 08:00 | Comments(0) | if
目次はこちら
IF...WHEN （複数条件）
$$ When reading an object, if an instance of that object with the requested version number exists in the content store...(USP01032209)
$$ In the case of an interpreted language being used for the interrupt handler, there would be a large overhead in entering the interrupt handler method if the method were called when an interrupt occurred.(USP02029357)
$$ If the system 1 (and therefore also the remote control 28) is in TV mode when any of the keys 77 to 80 are depressed, the processor 62 of the remote control responds by transmitting appropriate signals to the TV 2 and the decoder 3 to place the system 1 in the satellite configuration. / システム１が（したがって遠隔制御装置２８も）、キー７７ないし８０のいずれかを押してＴＶモードにある場合は、遠隔制御装置のプロセッサ６２が応答し、適切な信号をＴＶ２およびデコーダ３に送信して、システム１を衛星構成にする。(USP02042917)
$$ Moreover, even if this requirement is satisfied when the rotor is in the rest, it is likely to be violated when the rotor rotates with high speed due to radial expansion caused by centrifugal forces.(USP6304015)
$$ More specifically, if the peak current in the lamps 36 has a value Ｉmax when each transistor is turned off exactly at the end of the respective half cycle, the peak current flowing through the lamps will be given by Ｉmax.cosφ when the switch-off times are advanced by a phase angle φ. / より詳しく言うならば、各トランジスタが正確にそれぞれの半サイクルの終点でスイッチオフされる場合のランプ３６におけるピークの電流の値をＩmaxとするならば、スイッチオフの時刻が位相角でファイだけ進められた場合にランプを通して流れるピークの電流（の値）はＩmax・cosφで与えられる。(USP5434880)
目次はこちら
IF...WHEN （複数条件）
$$ When reading an object, if an instance of that object with the requested version number exists in the content store...(USP01032209)
$$ In the case of an interpreted language being used for the interrupt handler, there would be a large overhead in entering the interrupt handler method if the method were called when an interrupt occurred.(USP02029357)
$$ If the system 1 (and therefore also the remote control 28) is in TV mode when any of the keys 77 to 80 are depressed, the processor 62 of the remote control responds by transmitting appropriate signals to the TV 2 and the decoder 3 to place the system 1 in the satellite configuration. / システム１が（したがって遠隔制御装置２８も）、キー７７ないし８０のいずれかを押してＴＶモードにある場合は、遠隔制御装置のプロセッサ６２が応答し、適切な信号をＴＶ２およびデコーダ３に送信して、システム１を衛星構成にする。(USP02042917)
$$ Moreover, even if this requirement is satisfied when the rotor is in the rest, it is likely to be violated when the rotor rotates with high speed due to radial expansion caused by centrifugal forces.(USP6304015)
$$ More specifically, if the peak current in the lamps 36 has a value Ｉmax when each transistor is turned off exactly at the end of the respective half cycle, the peak current flowing through the lamps will be given by Ｉmax.cosφ when the switch-off times are advanced by a phase angle φ. / より詳しく言うならば、各トランジスタが正確にそれぞれの半サイクルの終点でスイッチオフされる場合のランプ３６におけるピークの電流の値をＩmaxとするならば、スイッチオフの時刻が位相角でファイだけ進められた場合にランプを通して流れるピークの電流（の値）はＩmax・cosφで与えられる。(USP5434880)
目次はこちら
※このブログではブログの持ち主が承認した後、コメントが反映される設定です。